Click Image for Gallery
Fail-safe brake setup:
* Connect the fail-safe unit to throttle / break servo and receiver.
* Be sure to observe the polarity of the wire leads.
* Apply full brakes on transmitter and press the set key for two seconds until you see the flashing red light pause.
* Check the function prior to actual operation by turning on the transmitter and moving throttle stick up and / or to brakes position.
* Then turn the transmitter off to insure fail safe has applied brakes.
Status LED :
Red (Flash) : when transmitter does not receive any interference. (ready to go)
Red (Solid) : there is radio interference. (Do not run)
Red (Solid) : Low battery warning. (Do not run)