The CA accelerator spray can be applied before or after the cyanoacrylate, but it works best when sprayed onto the surface to be glued before applying the ciano. This method vastly accelerates the curing process, crystallizing the cyanoacrylate almost instantly, eliminating the tedious waiting time for the adhesives to dry and allowing you to continue working immediately. Be prepared, as it can dry very fast!
How to use an Activator Spray for super glue?
To use an Activator Spray for super glue effectively, begin by preparing your workspace, ensuring it is well-ventilated to avoid inhaling fumes. Clean the surfaces to remove any dust or grease, then position the items correctly for bonding. Apply a small amount of cyanoacrylate to one surface, being careful not to over-apply. Shake it well, then lightly apply a fine mist onto the other surface, ensuring complete but not excessive coverage.
Immediately press the two surfaces together, allowing the accelerator to rapidly initiate the curing process. Hold the surfaces firmly for a few seconds to ensure a strong bond, as the cyano will harden almost instantly. After bonding, check the alignment and bond strength, and remove any excess carefully. Close the accelerator spray can and store it in a cool, dry place away from sunlight and ignition sources.
Always wear gloves and safety goggles for protection, and ensure proper ventilation. Keep this product away from open flames and store it securely.
Content: It contains 200ml of Activator Spray for Super Glue
Safety Notices:
- Use only outdoors or in a well-ventilated area.
- Do not breathe gas/fumes/vapor
- Keep out of the reach of children.
- Avoid contact with skin and eyes.
- Do not apply on naked flames or any incandescent material.
- Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F. Keep away from sources of ignition. No smoking.
- Keep the product tightly closed in a cool place and a place with adequate ventilation.
- Careful if applying onto painted parts, as it could harm dry paint.